Electronic Playground · Project 13 · on a breadboard

The Electronic Switch

A tiny current into the transistor's base opens a gate, and a bigger current flows from collector to emitter to light the LED. Press the button and watch both currents.

Power
OFF: LED dark
Base current (small) Main current (big) Pushing, but blocked

Where the current goes

Base path (the control)

    Main path (the LED)

      Same circuit, as a schematic

      Inside the transistor: a gate

      Why the transistor works like this

      Three legs. The collector (C) collects current from the LED. The emitter (E) lets it out to minus. The base (B) is the control handle.

      Button off: no current into the base, so the C→E gate is shut. The battery still pushes: the LED and collector side has voltage on it (shaded pink), but nothing flows, so the LED stays dark.

      Button on: a small current flows through the 10 kΩ into the base and out the emitter. That opens the gate, and a much bigger current flows through the 1 kΩ, the LED, and C→E.

      The gain. A transistor like this can pass about 100× its base current. Here the gate could pass far more than the LED needs, so the 1 kΩ sets the LED current. Engineers call this "fully on" or saturated: a perfect switch.

      Why the 10 kΩ? The base-emitter path behaves like a diode. With no resistor it would let a huge current through and burn out.

      The dots show conventional current, which runs from + to −, the way schematics are drawn. The real electrons drift the other way. It works the same.

      Check it with your meter

      GMT-318 on DCV 10 V, black probe on the − rail, red probe on the point.

      To see the main current, use DCA 250 mA and swap the meter in for the red jumper at column 21: red probe on the + rail, black probe in a21. On the 250 scale it shows as a small nudge.

      Playground springs ↔ breadboard holes

      PartPlaygroundBreadboard
      Battery + to 1 kΩ and switch27–41–56+ rail, jumpers to a4 and a21
      Switch to 10 kΩ55–45button e6 → column 6 → 10 kΩ b6
      10 kΩ to base44–1510 kΩ b11 → base e11
      1 kΩ to LED +40–11 kΩ b16 → LED long leg c16
      LED − to collector2–16LED short leg c12 → collector e12
      Emitter to battery −17–26emitter e10 → jumper a10 → − rail

      Transistor leg order E-B-C (flat face toward you) matches common NPNs like the 2N3904, PN2222A and S8050. Check your part's datasheet before plugging it in. This layout has not been built on a real breadboard yet.